|
Campden Tablets
(AKA: Sodium Metabisulphite)
Uses: Source of SO2 (sulphite) in wine making. For every 2 litres
of wine completely crush one tablet. Dissolve in a small amount of cold
water. Stir into wine thoroughly.
Contraindications: Not recommended because of the near impossibility
of successfully dissolving the tablets correctly (and thus achieving the
correct dosage). better choice would be potassium metabisulphite (see
below).
Iodaphor
Uses: Iodine detergent. Sanitizer. Germicide. Prepare solution
by mixing one ml of Iodaphor per litre of cold water. Use a syringe for
accurate measurement. Sluice equipment with solution (or use trigger-type
spray bottle) and allow to drip dry. Do not rinse. Excellent for use with
stainless steel (which Diversol will corrode and pit) and any other beer-making
equipment.
Contraindications: Hazardous to those with iodine allergies. Concentrated
solution will stain skin, fabric. Good sanitizer, but not good for cleaning
dirty or stained equipment. Must be made fresh for each use, and discarded
after 24 hours, as it loses potency with time.
Potassium Metabisulphite
Uses: Source of SO2 in wine making. For sulphite additions in wine
use ½ teaspoon per 23 litres to give 50 PPM. Dissolve in a small
amount of cold water. Stir into wine thoroughly. To make a 2.5% a cleaning
solution, dissolve 50 grams (about 8 teaspoons) into 4 litres of cold
water. 5 ml (one teaspoon) = approximately 6.1 g.
Hazard Classification: Irritant. Will provoke allergic reaction
in hypersensitive individuals. Individuals with asthma or emphysema should
not breathe the dust or SO2 gas from the prepared solution. Note that
due to media coverage, far more people consider themselves "allergic"
to sulphites than actually are.
Potassium Sorbate (AKA: Sorbic Acid)
Uses: Prevents renewed fermentation in sweet wines and inhibits
reproduction of mold and yeast. Do not add until all fermentation is finished
and the wine is clear and stable. Dissolve ¼ g of Sorbate per litre
of wine to be treated in cool water and then stir in thoroughly. 5 ml
(one teaspoon) = approximately 2.8 g.
Contraindications: Must not be added until all fermentation has
ceased. Sorbate present during malolactic fermentation will be converted
to hexanedienol (geraniol), a compound with the strong and disagreeable
odour of rotting geraniums. Not necessary in dry wines, although many
older recipe books insist on adding it under the name "Stabilizing
powder".
Composition: Stable salt of sorbic acid (derived from the berries
of the mountain ash tree).
Diversol
Uses: Sanitizing detergent. Extremely useful in cleaning all home
beer and wine-making equipment. Dissolve 3.5 g/litre of cold water to
make sanitizing solution. Allow to soak for at least 20 minutes. Rinse
thoroughly with hot water. For heavily stained equipment, soak for up
to 48 hours. 5 ml (one teaspoon) = approximately 3.8 g.
Contraindications: Due to highly alkaline nature of solution, should
not be mixed with acids, amines, ammonia, or reducing agents. Should not
be used with stainless steel due to corrosive pitting from chlorine.
Composition: Chlorinated alkali, consisting of chlorinated trisodium
phosphate and potassium bromide.
Hazard Classification: Corrosive. Contact with skin or eyes can
cause severe irritation. Also irritating if dust is breathed or swallowed.
Contact with acids or reducing agents will release heat and chlorine gas.
Contact with ammonia or nitrogen compounds will produce nitrogen gas and
chloramines.
Saniton
Uses: Detergent. Useful for cleaning all home beer and wine-making
equipment. Especially useful for stainless steel, where a chlorinated
cleaner such as Diversol could pit and corrode the metal. Removes very
stubborn stains and dirt. Dissolve 2 g/litre of warm water (about 2 teaspoons
per imperial gallon). Allow to soak for 20 minutes and scrub any stubborn
stains. Rinse well with hot water. 5 ml (one teaspoon) = approximately
4.3 g.
Contraindications: Not an effective sanitizer; must be used in
conjunction with bacterial inhibitors. Avoid contact with strong acids
and prolonged contact aluminum, tin, lead and zinc, as it will produce
hydrogen gas.
Composition: Sodium carbonate, sodium metasilicate.
Hazard Classification: Corrosive. Exposure to dust may cause irritation
to skin, eyes, and respiratory tract. If ingested can irritate digestive
tract.
Sodium Metabisulphite
Uses: Source of SO2 in wine making. Dissolve ½ teaspoon
per 23 litres in a small amount of cold water to give 50 PPM. Stir into
wine thoroughly. To make 2.5% a cleaning solution, dissolve 50 g (about
8 teaspoons) into 4 litres of cold water. 5 ml (one teaspoon) = approximately
6.1 g.
Contraindications: Sodium source of metabisulphite a health concern
to people prone to hypertension. Also, high doses could cause flavour
changes in wine. If this is of concern to you, potassium metabisulphite
could be a better choice.
Hazard Classification: IIrritant. Will provoke allergic reaction
in hypersensitive individuals. Individuals with asthma or emphysema should
not breathe the dust or SO2 gas from the prepared solution. Note that
due to media coverage, far more people consider themselves "allergic"
to sulphites than actually are.
Sulphur Strips
Uses: Source of sulfur dioxide for barrel care. Wicks are burnt
inside empty barrel, producing SO2 gas.
Contraindications: Difficulty in determining dosage rates for barrel
size. Large amounts of toxic sulfur dioxide gas released during use. A
solution of potassium metabisulphite would be a better choice for sanitizing
barrels.
Composition: Elemental sulphur bonded to cellulose wick.
Hazard Classification: Irritant. Gases produced by burning severe
irritant. Overexposure can lead to breathing difficulties.
The
Brewers Wort, 8A-140 Terminal Avenue, Nanaimo, B.C., V9R 5C5, 1-250-754-2448
Home : Premium Wines
: 30 Day Wines : Beer
: Ciders & Coolers : Resources
: Contact Us : Links
Copyright © 2002, 2003, 2004, 2005 The Brewers Wort
Last Updated: May 6, 2005
|